Prep is the part that cannot be skipped
Most coating failures start before the coating is installed. If the slab still has curing compounds, paint, sealer, grease, or a weak surface layer, the floor will not hold the way it should. Concrete grinding and prep is what creates the profile and clean substrate that resin systems need to bond.
We provide prep work for our own coating installs and for projects where the slab needs to be corrected before the next phase can start. In Plano, that often means removing old failed paint, opening cracks, addressing pitted concrete, and getting the floor back to sound material.
What proper prep includes
- Grinding to profile: We use diamond grinders to reach the profile the coating system calls for.
- Repair of visible defects: Cracks, spalls, divots, and weak edges are repaired before finish work begins.
- Review of contamination: Oil, chemicals, or moisture issues can change the prep plan and the coating recommendation.
Plano slabs often need corrective work
Garage and commercial slabs across Plano and nearby North Dallas cities often come with sealers, tire residue, overspray, drywall dust, construction traffic, or old coating failure. Sometimes the concrete itself is fine and only needs profiling. Other times the surface layer is weak and has to be cut back farther. We assess that in the field rather than guessing from photos.
Why this matters for every coating type
Epoxy, polyaspartic, urethane, and cementitious systems all depend on the surface below them. If the prep is wrong, the chemistry choice will not save the install. That is why we treat surface prep as its own trade, not a quick setup step.
If your floor has old paint, failed coating, surface damage, or bond concerns, we can inspect it and lay out the prep scope first.